Technical Data - Scheppach Air Case Originalbetriebsanleitung

• The work area must be separated from the com-
pressor so that it cannot come into direct contact
with the working medium.
Operating pressure vessels
• You must keep your pressure vessel in good work-
ing order, operate the vessel correctly, monitor the
vessel, carry out necessary maintenance and re-
pair work immediately and meet the relevant safety
precautions.
• The supervisory authority may enforce essential
control measures in individual cases.
• A pressure vessel is not allowed to be used if it has
faults or deficiencies that can endanger workers
or third parties.
• Check the pressure vessel for signs of rust and
damage each time before using. Do not use the
compressor with a damaged or rusty pressure
vessel. If you discover any damage, then please
contact the customer service workshop.
Safety instructions for accessories
• Check the air pressure with a suitable manom-
eter after filling.
• RISK OF FIRE, EXPLOSION AND DAMAGE TO
HEALTH! The device must be used in well-venti-
lated areas only.
• DANGER OF INJURY! Never exceed the maxi-
mum allowable working air pressure of 8 bar. Use
a pressure reducer to set the working air pressure.
• RISK OF RECOIL FORCES! High working pres-
sures can give rise to recoil forces that under cer-
tain conditions can result in danger from continu-
ous loading.
• DANGER OF INJURY! IMPROPER USE! Never
point the device at people or animals.
• DANGER OF INJURY! Never use oxygen or other
combustible gas as the energy source.
• DANGER OF INJURY! First disconnect the
hose from the compressed air source and on-
ly then disconnect the compressed air supply
hose from the device. This will ensure that the
compressed air supply hose does not wave around
or recoil in an uncontrolled manner.
• For your own safety, wear suitable personal
protective equipment.
• Keep children and other people away while you
are operating the device. Distractions can cause
you to lose control of the device.
• Disconnect the device from the compressed air
source before carrying out any repairs or mainte-
nance of the device or moving it to another loca-
tion.
• When removing the hose coupling, hold the hose
tightly in your hand to avoid injury caused by the
hose shooting backwards.
• Look out for damage on the device. Check the
device for damage before bringing it into use. Do
not use the device if you discover any defects.
• Do not kink the device's hose, otherwise you may
damage it.
• NOTE! Observe the safety advice provided by the
manufacturer of your inflatable article.
• Do not remove rating plates or labels - they are
safety-relevant parts of the device.
• If you are inexperienced in the use of this type of
device, you should seek out information or training
to learn how to handle it safely.
Do not lose these safety instructions

6. Technical data

Mains connection
Motor rating
Operating mode
Compressor speed
Pressure vessel capacity
Operating pressure
Theoretical intake capacity
Theoretical delivery rate
Protection type
Weight of the unit
*S3 15% = periodical intermediate duty with a duty
cycle of 15% (1.5 min based on a 10 minute period)
The noise emission values were measured in ac-
cordance with EN ISO 3744.
Wear hearing protection.
The effects of noise can cause a loss of hearing.
Noise data
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB (A),
please wear suitable hearing protection.
Sound power level L
Sound pressure L
Uncertainty K
www.scheppach.com
220 - 240 V~ 50 Hz
max. 1100 W
3750 min
approx. 8 bar
approx. 180 l/min
approx. 95 l/min
95 dB(A)
wA
pA
2,09 dB(A)
wA/pA
S1
-1
2 l
IP20
8 kg
73 dB(A)
GB | 19