Motor Unit With Multisander Attachment Pkga2; Attaching/Removing­sanding­sheet; Connecting­dust­extraction; Sanding - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB IE
­ The­necessary­torque­is­dependent­on:
-­ the­type­and­hardness­of­the­ma-
terial­to­be­treated;
-­ the­type­and­length­of­the­screws­
used.
Motor unit with
multisander
attachment PKGA2
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
­ Wear­a­protective­mask­during­
grinding­work.
Attaching/removing­sanding­
sheet
The­sanding­plate­(21)­is­fitted­with­Velcro­for
rapid­attachment­of­the­sanding­sheet.­
Attaching sanding sheet
1.­ Press­the­sanding­sheet­(23)­evenly­onto­
the­sanding­plate­(21).­Ensure­that­the­
holes­in­the­sanding­sheet­are­placed­
above­the­openings­in­the­sanding­plate.
Removing sanding sheet
2.­ Simply­pull­the­sanding­sheet­(23)­off­
the­sanding­plate­(21).
Connecting­dust­extraction
You­can­reduce­dust­production­during­sand-
ing­by­attaching­a­dust­extraction­system.­
1.­ Push­the­adaptor­(24)­into­the­opening­
on­the­multi-sander­attachment­(22)­as­
far­as­the­stop.
2.­ Connect­a­dust­extractor­suction­hose­
to­the­adaptor­(24).
38
­ Make­sure­that­the­dust­extraction­sys-
tem is suitable for the material to be
cut. This information can be found in
the­operating­instructions­of­the­exter-
nal device.
­ If­necessary,­you­can­connect­the­suc-
tion hose of a vacuum cleaner with-
out­reducer­(25)­to­the­adapter­(24).

Sanding

•­ Use­a­dust­extraction­system­when­sand-
ing­with­the­multi-sander­attachment.
•­ Move­the­appliance­against­the­work-
piece­once­it­is­switched­on.
•­ Clean­the­sanding­plate­before­you­at-
tach a sanding sheet.
•­ Only­work­with­sanding­sheets­in­per-
fect condition to achieve good sanding
results.
•­ Work­using­low­and­even­pressure.­
This­protects­the­appliance­and­the­
sanding sheet.
• Do not use the same sanding sheet to
sand­different­materials­(e.g.­metal­
and­then­wood).

Selection of sanding sheet

Grain size P Application
for­pre-sanding­rough­wood­
P 60
surfaces
P­80­/­120 for­plain­sanding
for­fine­sanding­of­primed­
P 240
and­painted­surfaces