Use; Connect With Compressor - Parkside PDZ 25 A1 Bedienungs- Und Sicherheitshinweise

When removing the hose cou-
pling, hold the hose firmly in your
hand to prevent injuries caused
by the hose springing back.
Watch out for damage. Check
the product for damage before
first use. If the product shows de-
ficiencies, it cannot be operated
in any circumstances.
The product may only be oper-
ated using cleaned, oil-free and
condensate-free compressed air.
CAUTION! RISK OF INJURY!
Keep children and other people
away from the product during use.
You could lose control of the
product if you are distracted.
Be attentive while working! Pay
attention to what you are doing.
Proceed with caution.
Avoid uncomfortable positions.
Make sure that you are standing
firmly and that your weight is
evenly balanced.
Wear suitable working clothes.
Wear tight-fitting clothing, non-slip
shoes, a hairnet, or tie back your
hair. Jewellery or loose-fitting
clothing can get stuck in moving
parts of the product.
Keep your workplace clean.
Disorder can lead to accidents.
Do not use the product in a damp
or wet environment.
14 GB/IE
of the work environment must
wear protective goggles and
earmuffs.
Remove the product from the com-
pressed air source before repair
and maintenance work and be-
fore transport.
Do not carry the compressed air
device by the hose, but by the
housing instead.
Do not kink the compressed air
hose. This could cause damage.
NOTE! Please observe all manu-
facturer's instructions regarding
inflatable articles.

Use

Note: please remove all packaging material from
the product.
Note: seal all male threads on the pneumatic
accessories with teflon tape.

Connect with compressor

(A) Connect a quick coupling
the pneumatic hose
with a quick plug nipple
quick plug nipple
3
on the compressor.
(B) Connect a quick plug nipple
matic device. Then plug the quick plug nipple
that is connected to the pneumatic device into
the quick coupling
the pneumatic hose. The pneumatic device is
now ready for use.
Every person in
the direct vicinity
with one end of
2
; connect the other end
1
. Then insert the
3
into the quick coupling
with the pneu-
4
that is connected with
2
4