Selection Of Sawblade; Motor Unit With Multifunction Tool Pkga4; Changing­the­tool; Attaching/Removing­sanding­sheet - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

GB IE
1. Place the device with the bottom edge
of­the­footplate­(17)­on­the­workpiece.
2. Turn on the device.
3.­ Insert­the­saw­blade­(20)­in­the­workpi-
ece­by­tipping­the­device­forward­until­
the device is vertical.
4.­ Continue­sawing­along­the­desired­cut-
ting line.

Selection of sawblade

Wood sawblade
Metal­sawblade
Plunge sawblade
Motor unit with
multifunction tool
PKGA4
­ Wear­a­protective­mask­during­
grinding­work.
Changing­the­tool
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
­ Ensure­that­the­tool­holder­(29)­is­
tightly screwed in to ensure you can
safely­mount­and­use­all­the­sup-
plied­tools­(30/32/33).
1.­ Push­the­lever­(27)­for­tool­unlocking­
upwards­as­far­as­the­stop.
2.­ Place­the­desired­tool­(30/32/33)­be-
low­the­tool­holder­(29)­on­the­arbors­
40
for­wood,­plastic,­plaster-
board
for­metal­sheets,­profiles­
and tubes
for­soft­materials­like­
wood­or­plasterboard
(28).­You­may­need­to­rotate­the­un-
locked­tool­holder­(29)­as­far­as­need-
ed­to­allow­you­to­place­the­desired­
tool­(30/32/33)­onto­the­arbors­(28).­
12­different­positions­are­possible.
3. Rotate the tool holder as required until
it­is­firmly­in­place.
4.­ Push­the­lever­(27)­for­tool­unlocking­
forwards again. The tool holder is
fixed­to­the­tool.
Attaching/removing­sanding­
sheet
The­delta­sanding­plate­(30)­is­fitted­with­
Velcro­for­rapid­attachment­of­the­sanding­
sheet.
Attaching sanding sheet
1.­ Press­the­sanding­sheet­(31)­evenly­
onto­the­delta­sanding­plate­(30).­En-
sure that the holes in the sanding sheet
are­placed­above­the­openings­in­the­
sanding­plate.
Removing sanding sheet
2.­ Simply­pull­the­sanding­sheet­(31)­off­
the­delta­sanding­plate­(30).

Sanding

•­ Move­the­appliance­against­the­work-
piece­once­it­is­switched­on.
•­ Clean­the­sanding­plate­before­you­at-
tach a sanding sheet.
•­ Only­work­with­sanding­sheets­in­per-
fect condition to achieve good sanding
results.
•­ Work­using­low­and­even­pressure.­
This­protects­the­appliance­and­the­
sanding sheet.
• Do not use the same sanding sheet to
sand­different­materials­(e.g.­metal­
and­then­wood).