Motor Unit With Drill Attachment Pkga1; Changing­the­tool; Choice­of­gear; Set The Direction Of Rotation - Parkside PKGA 20-Li C2 Originalbetriebsanleitung

Overview of the control display on
the charger (14):
Green LED lights up without battery in-
serted: Charger­ready.
Green LED lights up: Battery such alleged
charged.
Red LED lights up: Battery charging.
Motor unit with drill
attachment PKGA1
Changing­the­tool
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1.­ Rotate­the­keyless­chuck­(1)­towards­
­until­the­drill­chuck­aperture­is­
RELEASE
large enough to accommodate the tool.
2.­ Insert­the­tool­as­far­as­possible­into­
the­keyless­chuck­(1).­
3.­ Turn­the­keyless­chuck­towards­
order­to­clamp­the­tool.
4. To remove the tool again, rotate the
keyless­chuck­(1)­towards­
the­drill­chuck­aperture­is­large­enough­
to remove the tool.
Choice­of­gear
­Stop­appliance­before­
changing gear.
1.­ Wait­for­the­appliance­to­come­to­a­
standstill.
2­­ Slide­the­gear­selector­(3)­into­the­re-
quired­position:
1: 0-400 min
-1
2: 0-1350 min
GRIP
RELEASE
-1

Set the direction of rotation

The­appliance's­direction­of­rotation­can­
be changed with the rotational direction
switch.
The arrow on the direction switch indicates
the­working­direction.
1.­ Wait­for­the­appliance­to­come­to­a­
standstill.
2.­ Push­the­rotational­direction­speed­
(7)­into­the­desired­position:
To drill and screw in screws: Press the
direction­switch­with­the­arrow­poin-
ting forwards
To unscrew screws: Press the direction
switch­with­the­arrow­pointing­back-
wards
3.­ If­you­place­the­direction­switch­
(7)­in­the­middle­position,­the­device­is­
secured against being switched on.
The direction change may only be
actuated­when­at­a­standstill!

Torque adjustment

in
You­can­preselect­the­maximum­torque.­
The­torque­settings­are­labelled­1­-­19­+­
until
1.­ Wait­for­the­appliance­to­come­to­a­
standstill.
2.­ Turn­the­torque­adjusting­ring­(2)­to­
select the desired torque:
Screws: ­
Drilling:­­
3. Start with a lower torque­step­and­
increase as required.
The direction change may only be
actuated­when­the­appliance­is­at­a­
standstill!
GB
Steps­1­-­19
Step­
IE
37