Simons Voss Technologies Cylinder AX EC thumb turn Kurzanleitung Seite 45

5. Installation on the removed cylinder
(anticlockwise unlocking)
9. Tighten the fastening screw.
Re-fitting the electronic thumb-turn
1.5 mm hexagonal wrench available.
ü
1. Align the thumb turn mount horizontally.
2. Attach the thumb turn.
NOTE
Use the supplied hexagonal wrench.
The special tool is supplied with a hexagonal
wrench.
Use this hexagonal wrench to mount and dis-

mount the electronic thumb turn.
3. Insert the hexagonal wrench into the hole provided until
it stops.
4. Turn the hex key 270 degrees clockwise.
5. Pull out the hexagon wrench again.
6. Put on the cover.
7. Turn the cover clockwise.
The cover snaps into place with one click.
9
The electronic thumb turn is installed.
9
Functional test
1. Turn and pull the escape thumb-turn to check that it is
45 / 72 | EN