Enclosure quality
7.5
Envelope and Insert Specifications
Envelope quality
Minimum size
Maximum size
* In case of fold only (no insert): height > 120 mm / 4.7
** When insert is more than 1 mm (0.04 inch): A-15 mm / A-0.6 inch
Remarks:
•
Maximum insert specifications are based on single sheets. When multiples are
handled, more room inside the envelope is needed depending on the application.
•
The specification of the paper handling equipment is often wider than that of the
envelopes and documents handled. The condition of material handled will limit the
specified environmental conditions.
•
We recommend that materials to be handled are stored at a temperature of 20°C
(68°F) with a relative humidity factor of 50%. If difference in temperature occurs
between store room and mailing area, the material has to be stored near the system
at least 24 hours before use.
•
Self-copying paper may cause rubber parts to wear quicker. The rubber used in this
system has the best resistance to Wiggins Teape material.
28
BRE, minimum: 75 g/m² (18.75 lb bond)
BRE, maximum: 120 g/m² (30 lb bond)
Insert, minimum: 75 g/m² (18.75 lb bond)
Insert, maximum: 250 g/m² (62.5 lb bond)
Minimum: 75 g/m² (18.75 lb bond)
Maximum: 120 g/m² (30 lb bond)
A
B
mm
229
105
inches 9.0
4.1
mm
241
162
inches 9.5
6.4
C
D
E
32
10
142
1.25
0.40
5.6
54
35
A-12**
2.1
1.4
A-0.47** B-0.24
F
G
90*
2
70 g/m
3.5
B-6
1.5
0.06