FP FPi 600 Betriebsanleitung Seite 26

Symptom Possible cause
Double Different types of
documents are documents fed.
fed, but the
system does not
Documents out of
notice.
specification.
6.3.5 Insert problems
Symptom Possible cause
System stops with Envelopes stacked
envelope at insert reversed in the
position (flap not hopper.
open).
Envelope flap sticks.
Wrong envelope type
used (not according
to specifications or
job settings).
Fingers are placed Envelope stops too
on top of the early.
envelope.
System stops Inserted document
while inserting too long or not
(stoppage at the correctly folded.
inserting point).
Envelope throat
incorrect.
Envelope glued
inside.
Window not glued
properly.
Envelope not Inserted document
always ejected too big.
from sealer.
Document not
inserted deep
enough.
Sealing area dirty.
Address not Address position not
readable from correctly defined.
window
Remedy
Use daily mail to
process different
document types.
Check document
specifications.
Remedy
Check envelope feed
adjustments. Place
envelopes correctly
in hopper.
Store envelopes
according to
specifications.
Change envelopes
according to
specifications.
Check envelope stop
position, adjust if
needed.
Make sure the
document size and
enclosure size equals
the job settings.
Check envelope
specifications.
Eliminate faulty
envelopes.
Eliminate faulty
envelopes.
Make sure the
document size and
enclosure size equals
the job settings.
Check adjustment of
envelope stop
position.
Clean sealing area.
Check address
position.
Reference
"Document
Specifications" on
page 27
Reference
"Loading Envelopes" on
page 14
"Envelope and Insert
Specifications" on
page 28
"Envelope and Insert
Specifications" on
page 28
"Envelope Position" on
page 26
"Envelope and Insert
Specifications" on
page 28
-
-
"Envelope Position" on
page 26
"Operator Maintenance"
on page 19
"Address Position" on
page 26
25