FP FPi 600 Betriebsanleitung Seite 31

Term
Document set
Double Feed
Control (DFC)
Double V-fold
Envelope
Face down
Face down
leading
Face down
trailing
Face up
Face up leading
Face up trailing
Feeder
30
Description
The document set is the physical collection of address carrier and
enclosure(s) that is under production in the inserting system. The
document set is completed during production and is to be inserted into
the envelope. The number of enclosures can range from 0 to the limit
opposed by the number of available feeders. Once the document set
has been inserted into an envelope it is called mail set.
Double Feed Control is the sensor that measures the thickness of a
sheet to check if the inserting system does not accidentally take more
sheets than intended. DFC sensors exist on feeders (double sheet
detection). Currently DFCs on Neopost inserting systems perform
relative measurements, which means that they need a cycle to 'learn'
the thickness of a sheet.
Also the length of the document is measured so partly overlapping
sheets will be detected.
The double V-fold is a type of fold where the document is first folded
halfway and the resulting folded set is again folded halfway. This fold is
illustrated in the picture below. The position of both folds is adjustable.
Synonym: double parallel fold.
The envelope is the packaging of a mail set. Window envelopes are
envelopes that have a transparent section through which the address
on the address carrier can be read. Besides the normal top closing
window envelopes there are also bottom closing envelopes.
Situation in which the front of a sheet is facing downwards when
placed in a document feeder.
Situation in which the front of a sheet is facing downwards and the top
of the sheet is closest to the separation unit in a document feeder.
Situation in which the front of a sheet is facing downwards and the
bottom of the sheet is closest to the separation unit in a document
feeder.
Situation in which the front of a sheet is facing upwards when placed
in a document feeder.
Situation in which the front of a sheet is facing upwards and the top of
the sheet is closest to the separation unit in a document feeder.
Situation in which the front of a sheet is facing upwards and the
bottom of the sheet is closest to the separation unit in a document
feeder.
A feeder is a module for the input of documents to the inserting
system. The feeder separates documents sheet by sheet from the
stack of documents in the feeder tray.