FP FPi 600 Betriebsanleitung Seite 24

6.3.2 Envelope Sealing Problems
Symptom Possible cause
Envelope not Insufficient
closed properly. moistening.
The current job has
no envelope sealing.
Document or
enclosure not
compliant with job
specification.
Documents are not
correctly inserted.
Envelope contents Sealing position is
is wet. not correctly set.
Exit roller is wet.
Flap not Water level low.
sufficiently
moistened.
Brushes dry.
Brushes dirty.
Brushes worn out.
The current job has
no envelope sealing.
Envelope does not
meet the
specifications.
Poor envelope
quality.
Sealing position is
not correctly set.
Remedy
Make sure if the job
is programmed to
seal envelopes.
Make sure the
document size and
enclosure size equals
the job settings.
Make sure the side
guides of the
document feeders
are in the correct
position.
Check envelope stop
position, adjust if
needed.
In the supervisor
menu change the
settings of the
applicable envelope.
Clean the exit roller.
Check water level,
refill if needed.
Check brushes,
replace if needed by
the extra soaked set.
Check brushes, clean
if needed.
Replace brushes.
Choose job with
envelope sealing.
Make sure the
envelope meets the
specifications.
Seal an envelope
manually to test the
adhesion quality.
In the supervisor
menu change the
envelope settings.
Reference
See symptom "Flap not
sufficiently moistened."
on page 23.
"Job Programming" on
page 17
"Adjusting the Side
Guides of the Document
Feeder" on page 13
"Envelope Position" on
page 26
"Sealing position" on
page 26
"Clean the System" on
page 19
"Filling the Sealing
Liquid Reservoir" on
page 15
"Operator Maintenance"
on page 19
"Operator Maintenance"
on page 19
"Operator Maintenance"
on page 19
"Envelope and Insert
Specifications" on
page 28
23