FP FPi 600 Betriebsanleitung Seite 27

6.3.6 Envelope Position
To make a good insert of the document set into
the envelope, the envelope should be positioned
correctly.
To verify the envelope position:
1. Go to the supervisor menu.
2. Press Adjust stop position.
3. Choose the envelope type and press the
arrow button.
4. Press the 1x button. Make sure that the
document set is completely inserted into the envelope.
5. If not, use the arrow buttons to adjust the envelope position.
6. Repeat step 3 and 4 until the envelope position is correct.
7. Press the
6.3.7 Address Position
The address on the document set should be
positioned in a way that you can read it from the
envelope window. If it is not readable, adjust the
address position as follows:
1. Choose a job and press the 1x button.
2. Press the No button if asked if the address is
visible.
3. Use the arrow buttons to adjust the address
position.
4. Press the 1x button again to verify the new
position.
5. Press the Yes button if the position is correct.
6.3.8 Sealing position
If the sealing area of the envelope is not correctly
moistened, adjust the sealing position as follows:
1. Go to the supervisor menu.
2. Press Adjust moistening position.
3. Choose the envelope type and press the
arrow button.
4. Use the arrow buttons to adjust the sealing
position.
5. Press the 1x button to test the new position.
6. Press the
correct.
26
button.
button if the position is