Using The Machine - Stiga ST 700 Li 48-Serie Gebrauchsanweisung

5.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
5.1.1 Unpacking
1. Cautiously open the packaging, paying atten-
tion not to lose components.
2. Consult the documentation in the box, includ-
ing these instructions.
3. Remove all the unassembled parts from the
box.
4. Lift the snow thrower from the box.
5. Dispose of the box and packaging in compli-
ance with local regulations.
5.2 HANDLE ASSEMBLY
1. Mount the middle part of the handle (Fig. 2.A)
onto the lower handle, securing it with the
quick-release fasteners (Fig. 2.B) on both
sides.
2. Place the upper handle (Fig. 2.C) onto the
middle handle and secure it with the quick-
release fasteners (Fig. 2.B)
3. Secure the electrical cable with the cable
grommets provided (Fig. 3.A).
5.3 DISCHARGE CHUTE ASSEMBLY
1. Place the discharge chute in line with the
three tabs on the machine (Fig. 4.A).
2. Secure it with the screw provided (Fig. 4.B).
5.4 ASSEMBLY
CHUTE ROTATION ROD
1. Slide the rod through the central handle holder
(Fig. 5.A).
2. Insert the end of the rod into the coupling hole
of the chute (Fig. 5.B), holding it in a straight
position with the handle pointing upwards.
3. Fasten with the cotter pin provided (Fig. 5.C)
4. Make sure the discharge chute rotates freely
(Fig. 5.D ).
6. CONTROLS
6.1 IGNITION KEY
Used to start and stop the electric motor. The
ignition key must be inserted into the ignition key
slot on the battery compartment. (Fig. 6. A):
OF THE DISCHARGE
1. Key removed: the engine stops and cannot
be restarted.
2. Key inserted: the engine can be turned on and
started.
6.2 STARTER LEVER
Enables the stopping and starting of the engine.
1. Start: Press the release button (Fig. 7.A) and
pull the start lever (Fig. 7.B).
2. Stop: release the starter lever (Fig. 7.B).
6.3 RELEASE BUTTON
It prevents accidental activation of the starter
lever. Press the button (Fig. 7.A) to release the
starter lever.
6.4 DISCHARGE CHUTE
ADJUSTMENT HANDLE
This controls rotation of the discharge chute so
that snow discharge can be aimed in the required
direction. Turn the handle (Fig. 8.A) clockwise /
anticlockwise to position the chute.
6.5 DEFLECTOR ADJUSTMENT
Hold the handle (Fig. 9.A) and press the lever
(Fig. 9.B) to position the deflector (Fig. 9.C) in the
desired position.
6.6 LED LIGHTS
The lights illuminate when the machine is started.
They switch off when the machine stops.

7. USING THE MACHINE

Before starting to work, it's necessary to carry out
several checks and operations to ensure you can
work efficiently and in maximum safety.
7.1 PRELIMINARY PROCEDURES
7.1.1 Battery check and recharging
Before each use:
• check the battery charge status according to the
instructions in the battery booklet.
EN - 9