Alarms And Error Messages - Austroflamm Ruby Benutzerhandbuch

english

4 Alarms and Error Messages

Alarms are displayed in yellow on the control panel. The pellet stove can continue to be used when an alarm is
indicated. Alarms are displayed in red. The pellet stove is inoperable when an error is displayed.
Warning code,
Error code
Alarm - A001
Alarm - A002
Alarm - A003 Flue gas temperature
Alarm - A004
Error- E002
communication error
Error- E004 Communication error
Error- E101
Negative pressure too
Error- E102
Error- E107
Error- E108
Error- E109
Defective room tem-
Error- E110
Error- E113
Firebox temperature
Error- E114
Error- E115
Description
Fuel fill level low
Service due
Weak battery
IR
Failed ignition
low
or too high
Firebox sensor
Safety switch I01
error
Safety switch I02
error
perature sensor
Excessive flue gas
temperature
too low
System shut down
13
reset the fill level indicator to "FULL".
Maintenance by a service technician is necessary.
Flue gas temperature too high; service technician required.
Replace the storage battery (CR2032) of the control unit.
The battery must be replaced every 2 years as part of the
Infrared sensor malfunction;
contact service technician.
Communication error between the control unit and the display;
check data cable plug connections.
1. The automatic start process was terminated manually.
2. Supply air pipe, burner pot, flue gas outlets, flue gas fan or
flue pipe clogged.
3. Chimney stack dirty.
4. Chimney draught too strong.
Firebox temperature sensor cable defective;
call customer service.
RESET the safety temperature limiter (STB)!
Caution: STB can only be reset after cooling below 105°C.
1. Pellet hopper lid is open.
2. Riddling grate not closed.
3. Jumper on IO2 not correctly plugged in.
If the fault persists, contact the service technician.
Room temperature sensor defective. Replace sensor.
Contact service technician.
Chimney fan and flue gas ducts are clogged;
cleaning is required.
(Empty the burner pot and restart the appliance).
2. The hopper is empty (refill the fuel hopper).
3. DC side of the control unit must be earthed.
((The furnace body has generated millivolts).
Software must be reloaded.
Contact a service technician.
Solution
Refill pellets;
.
service.
Restart.
Possible causes:
Possible causes:
1. Failed ignition.