Pairing With A Homematic Ip Floor Heating Actuator - eQ-3 homematic IP HmIPW-WTH Installations- Und Bedienungsanleitung

Start-up
All manuals and user guides at all-guides.com
5.4.1 Pairing with a Homematic IP Floor Heating
Actuator
You can cancel the pairing procedure by briefly
pressing the system button (D) again. This will be
indicated by the device LED (D) lighting red.
If no teach-in operations are carried out, teach-in
mode is exited automatically after 30 seconds.
If you want to pair the wall thermostat with a Homematic
IP Wired Floor Heating Actuator, the pairing mode of both
devices has to be activated first. To do this, proceed as
follows:
• Select the required channel on the floor heating
actuator that you want to connect to the wall
thermostat. For further information, please refer
to the operating manual of the floor heating ac-
tuator.
• Press and hold down the system button of the
floor heating actuator for 4 s until the LED quickly
starts flashing orange. The pairing mode of the
selected channel remains activated for 3 minutes.
• Press and hold down the system button (D) of
the wall thermostat for at least 4 seconds to acti-
vate the pairing mode (see fig. 3). The device LED
flashes orange.
58