eQ-3 homematic IP HmIPW-WTH Installations- Und Bedienungsanleitung Seite 75

Start-up
All manuals and user guides at all-guides.com
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button
(D) briefly (see figure 8).
• Your device will automatically appear in the
Homematic IP app.
• To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
• Please wait until teach-in is completed.
If teaching-in was successful, the LED (D) lights
•
up green. The device is now ready for use.
• If the LED lights up red, please try again.
• Select the desired solution for your device.
• In the app, give the device a name and allocate
it to a room.
If you are already using Homematic IP devices in
your smart home system or if you want to com-
bine your Homematic IP Wired devices with wire-
less Homematic IP components, you can also
connect the Homematic IP Wired devices to an
(installed) Access Point. Therefore, connect the
Homematic IP Wired Access Point to the (in-
stalled) Homematic IP Access Point, as described
in the user manual. Afterwards, please proceed as
described above to connect the wall thermostat.
62