Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
5.2
Installation
The bus is supplied by the Homematic IP Wired
Access Point (HmIPW-DRAP). For further infor-
mation, please refer to the operating manual of
the Wired Access Point.
For the installation, please proceed as follows:
•
Connect the Homematic IP Wired bus to the bus
connecting terminals (G) (see fig. 3). For connec-
tion and removal of individual wires, use a small
screwdriver to press down the orange clamp.
Place the mounting plate (F) into the flush-
•
mounted box and fix it to the flush-mounted box
using the supplied screws (see figure 4).
•
Place the frame of your existing switch series or
the supplied clip-on frame (A) on the mounting
plate (A) (see figure 5).
•
Place the electronic unit (B) of the wall thermo-
stat into the frame, by properly engaging the
connection pins (H) into the appropriate bracket
of the mounting plate (see figure 6+7).
5.3
Installation in multiple combinations
You can mount the wall thermostat with the attachment
frame (A) provided or use it with frames of other
manufacturers as well as integrate the electronic unit
(B) into a multi-gang frame. For mounting with multiple
combinations, make sure that the mounting plate of the
Start-up
55
Werbung
Kapitel
Inhaltsverzeichnis
