John Bean BFH 2000 Betriebsanleitung Seite 66

2
1
4
3
6-9
7-18
66
All manuals and user guides at all-guides.com
Radangaben zu erfassen
6.5
Nota:
The internal Gauge is used only to measure the distance
between machine and wheel (Ofset).
Fig. 7-1 Internal Gauge calibration for rim distance.
1 Internal gauge with gauge head
2 Gauge head (feeler)
3 Telescoping point to read the distance X
4 Graduated scale.
Figure 7-18
Determining the distance by measuring with gauge arm.
Application:



The Gauge calibration is used to determine the
exact distance. Entering the distance manually
excludes the use of the EasyAlu function.
Gauge calibration
The Gauge should be used to measure the wheel-
machine distance only in MANUAL Mode.
position the Gauge Head on the rim, in the exact point
shown in the "Gauge Position" chapter.
Read the distance value on the graduated scale of the
rod, at the Telescoping point.
Recall the Rim Data Input function in the Menu and
proceed as shown in the 7.3.3.2 "Rim/machine
distance input" chapter.
BFH 2000