Инструкция по монтажу
iii Порядок установки.
Балансировочный станок
Для
правильной
воспользуйтесь чертежом главы i. Если станок
необходимо
закрепить,
использовать крепежные элементы диаметром 8
мм класса прочностью 8.8 или выше.
Кронштейны для хранения принадлежностей
• Распакуйте 4 штифта и стойки.
• Установите 4 штифта на стойки согласно рис. iii-1.
Приспособления зажима:
• Расположите приспособления на штифтах стойки.
Механический зажим Power
Рис. iii-2. Следуйте указаниям главы 6.
Монитор:
Рис.
iii-3. Крепление монитора.
Рис. iii-2. кронштейн VESA имеет три различных
места
крепления,
которые
положениями установки (1a-1b) дают 5 различных
вариантов установки по высоте.
Четыре винта (M4x10) крепления кронштейна VESA к
монитору входят в комплект поставки.
Рис. iii-3. При установке монитора в сборе с
кронштейном следует выбрать удобное для работы
место установки.
Монитор должен быть установлен таким образом,
чтобы оставался минимальный зазор между ним и
панелью
клавиатуры,
регулировать угол его наклона.
BFH 2000
All manuals and user guides at all-guides.com
:
установки
станка
то
рекомендуется
:
Clamp:
вместе
с
двумя
чтобы
можно
было
Installation Instructions
iii Installation procedures.
Wheel balancer:
Refer to the drawing in i for correct wheel balancer
positioning. If the wheel balancer needs securing, we
recommend fixing elements with a diameter of 8 mm,
quality 8.8 or higher.
Supports for Accessories:
• Unpack the 4 threaded accessory support studs and
the support plates.
• Refer to Figure iii-1. Fit the 4 threaded accessory support
studs and the plates.
Clamping devices:
• Put the clamping devices on the accessory studs.
Power Clamp
device:
Figure iii-2. Las instrucciones para la instalación se
hallan en el Capìtulo 6.
Monitor:
Figure
iii-3 Fitting the monitor
iii-2) The VESA support has three different fixing points,
which thanks to the two possible fitting positions (1a-1b)
provide 5 different possible fixing heights.
The 4 screws needed (M4x10) to fix the VESA support to
the monitor are part of the kit supplied.
iii-3) When fitting the monitor assembly you must choose
the appropriate fixing point.
The monitor assembly must be positioned in such a way
as to leave a minimum gap vertically between the monitor
and the keyboard support, allowing its angle to be
adjusted.
259