Light-Guide - gc D-Light Pro Bedienungsanleitung

IFU ILLUSTRATIONS
Figures
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Figure 15
Figure 16
Captions
Handpiece
Electronic module
Battery packs (x2)

Light-guide

Eye-protection shields
Slide the eye-protection shield (soft or hard version) on the end of the light guide
Charging station and power supply
Attaching the plug adapter
Connecting the charging station
Recharging the battery packs on the charging station
Inserting the electronic module into the handpiece
Inserting the battery pack into the handpiece
Inserting the light guide into the handpiece
Adjust the light angle; the light guide rotates 360°
Position the light guide tip close to the material for best results
Check the light guide attachment regularly
Check and clean both ends of the light guide
Selecting the curing program
Rotate the battery pack by quarter turns until your desired program faces the reference point.
Activating the curing light
Press the switch on the handpiece.
The curing light is activated for 20 seconds. After 10 seconds have passed, there will be a quick
tone and a fl ash of the light. At the end of the curing cycle, a tone will sound and the curing
light will stop. You can also press the switch to interrupt the curing cycle before its end.
Using the radiometer
Position the light-guide as shown in the illustration and activate the light in High Power mode
(HP). A green light indicates suffi cient power output, while a red light warns of an insuffi cient
power.
Autoclaving the handpiece sleeve & light-guide
CAUTION! Make sure to remove the electronic module and battery pack before placing the
handpiece in the autoclave.
® EN
D-Light Pro
DE
FR
IT
ES
NL
DA
SV
NO
PT
FI
EL
11