Adjusting The Working Angle With The Telescopic Arm; General Working Instructions; Using The Device As Grass Shears/Shrub Shears; Working With The Telescopic Arm - Parkside PGSA 12 A1 Bedienungsanleitung

GB IE
1. Loosen the adjusting screw (19).
2. Set the telescopic arm (13) to the desi-
red length.
3. Fix the position by tightening the adjus-
ting screw (19).
Adjusting the working
angle with the telescop-
ic arm
For a comfortable edge cut, the equipment
holder (15) of the telescopic arm can be
rotated by 90° to the right or left.
1. Press the release (18).
2. Turn the equipment holder into the desi-
red position.
3. The equipment holder must lock into pla-
ce audibly.
General working
instructions
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
• Comply with the device's maintenance
and cleaning instructions.
Using the device as grass
shears/shrub shears
Ensure objects such as wire, metallic
parts, stones etc. do not enter the
blades while trimming. This can cau-
se damage to the cutting unit. If the
blades become jammed with solid ob-
jects, turn the device off immediately.
• Ensure that the screws in the blade bar
are firmly in place.
• Only use sharp blades to ensure good
trimming performance and to protect
the device and rechargeable battery.
30
• Do not overload the device while wor-
king to such an extent that it comes to
a standstill.
Working using the grass shears
• Grass is best cut when it is dry and not
too high.
Working using the shrub shears
• Move the device in a steady forward
motion, or up and down in an arch-sha-
ped motion.
• The double-sided blade bar enables trim-
ming in both directions, or via pendulum
movements from one side to the other.
Working with the
telescopic arm
The telescopic arm may only
be used with the grass she-
ars blade!
During operation, make sure
that the grass shear blade
( 12) does not scrape
along the ground.
Slowly push the device on the wheels over
the ground. By doing so, you will achieve
an even cutting height.
Turn the equipment holder (
at the telescopic arm to perform a clean
cut along the lawn edge.
15) by 90°