Quickposition; Optifeed - struers Exotom-100 Gebrauchsanweisung

QuickPosition

OptiFeed

30
Exotom-100
Instruction Manual
Positioning of the cut-off wheel may be done automatically, by
simply pushing the joystick downwards until the cut-off wheel is
in contact with the workpiece. The force is automatically reduced
on contact, preventing damage to the cut-off wheel and the
workpiece.
After contact with the workpiece, the cut-off wheel is
automatically retracted 2mm, to be ready for cutting.
During cutting, Exotom-100 continuously measures the load on
the cutting arm.
The pre-set Feed and Force values are interpreted as maximum
values. Throughout cutting, Exotom-100 will try to stay as close
to these values as possible.
The factors that determine the load, are the shape and properties
of the workpiece.
Whenever the set maximum Force limit is reached, Exotom-100
will reduce the Feed rate to be able to maintain the present force.