Reading The Cutting Display - struers Exotom-100 Gebrauchsanweisung

Reading the Cutting Display

A
B
Cutting Mode
Cutting Parameters and Motor
Information
Exotom-100
Instruction Manual
The Cutting Display offers three types of information:
Cutting Mode
Cutting Parameters, and
Motor Information
Cutting Mode.
A
Cutting Parameters.
B
Motor Information.
C
The top bar displays the selected Cutting Mode:
Direct Cutting, ExciCut, AxioCut/Step or AxioCut/Sweep
(AxioCut/Step and -/Sweep are optional).
The large window on the Cutting Display, displays information
about the Cutting Parameters (FEED, FORCE, STOP) as well as
Motor information (TEMP, LOAD).
The Cutting Parameters (FEED, FORCE and STOP) can be set
both prior to and during cutting. The set value is displayed below
the column. Actual value is displayed above the bar graph.
The Motor Information columns TEMP and LOAD, inform about
the condition of the motor during cutting. Read-out in relative
value (%).
C
13