Measurement Stand-Alone With The Handheld - Bosch Vivatmo pro Bedienungsanleitung

Measure
4.2

Measurement stand-alone with the handheld

WARNING
The 6 second measurement mode is for research use only and not for use in diagnostic procedures.
Stand-alone measurements can be used when the handheld has no connection to the basestation.
The handheld must be out of range of the basestation or the basestation must be switched off.
The measurement procedure is guided by the handheld display and the LED on the upper side. Synchronize measurement
results of stand-alone measurements with the Vivatmo pro handheld by placing the switched on Vivatmo pro handheld in the
cradle of the Vivatmo pro basestation.
30 © Bosch Healthcare Solutions GmbH
1. Use the ON/OFF button to activate your Vivatmo pro handheld.
You see all screen icons and the system performs a brief self-test. Then the
software version installed on the handheld is shown shortly.
After the self-test, the handheld shows:
the audio icon on the handheld is activated,
•
the bluetooth connection is not activated. The Bluetooth icon is blinking, as
•
the handheld is not connected to the basestation.
2. The measurement mode is displayed in the settings bar. For changing press
ENTER for 3 seconds to reach the measurement mode selection, select with
the ARROW buttons and confirm with ENTER.
3. Attach a new disposable mouthpiece.
Instructions for use