Belden Hirschmann EAGLE Referenzhandbuch Seite 565

Link Layer Discovery Protocol (LLDP)
25.2 show
Parameter Value
2..10
P-1
2 5 .1 .7 lldp c onfig c ha ssis t x -int e rva l
Enter the LLDP transmit interval in seconds.

Mode: Global Config Mode

Privilege Level: Operator

Format: lldp config chassis tx-interval <P-1>
Parameter Value
5..32768
P-1
2 5 .2 show
Display device options and settings.
2 5 .2 .1 show lldp globa l
Display the LLDP global configurations.

Mode: Command is in all modes available.

Privilege Level: Guest

Format: show lldp global
2 5 .2 .2 show lldp port
Display the port specific LLDP configurations.

Mode: Command is in all modes available.

Privilege Level: Guest

Format: show lldp port [<P-1>]
Parameter Value
slot no./port no.
P-1
2 5 .2 .3 show lldp re m ot e -da t a
Remote information collected with LLDP.

Mode: Command is in all modes available.

Privilege Level: Guest

Format: show lldp remote-data [<P-1>]
Parameter Value
slot no./port no.
P-1
2 5 .3 lldp
Configure of Link Layer Discovery Protocol on a port.
2 5 .3 .1 lldp a dm in-st a t e
Configure how the interface processes LLDP frames.

Mode: Interface Range Mode

Privilege Level: Operator

Format: lldp admin-state <P-1>
Parameter Value
P-1 tx-only
rx-only
tx-and-rx
disable
106
Meaning
Enter a number in the given range.
Meaning
Enter a number in the given range.
Meaning
Meaning
Meaning
Interface will only transmit LLDP frames. Received frames are not processed.
Interface will only receive LLDP frames. Frames are not transmitted.
Interface will transmit and receive LLDP frames. This is the default setting.
Interface will neither transmit nor process received LLDP frames.
RM CLI EAGLE20/30
Release 04.1 03/2021