Belden Hirschmann EAGLE Referenzhandbuch Seite 552

2 1 .1 .1 2 ip ospf a ut o-c ost
Set the auto cost reference bandwidth of the router interfaces for ospf metric calculations. The default reference
bandwidth is 100 Mbps.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf auto-cost <P-1>
Parameter Value
P-1 1..4294967
2 1 .1 .1 3 ip ospf dist a nc e int ra
Enter the preference type as intra. Use intra-area routing when the device routes packets solely within an area,
such as an internal router.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf distance intra <P-1>
Parameter Value
P-1 1..255
2 1 .1 .1 4 ip ospf dist a nc e int e r
Enter the preference type as inter. Use inter-area routing when the device routes packets into or out of an area,
such as an area border router.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf distance inter <P-1>
Parameter Value
P-1 1..255
2 1 .1 .1 5 ip ospf dist a nc e e x t e rna l
Enter the preference type as external. Use external-area routing when the device routes packets into or out of an
autonomous system, such as an autonomous system boundary router (ASBR).

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf distance external <P-1>
Parameter Value
P-1 1..255
2 1 .1 .1 6 ip ospf re -dist ribut e
Configure the OSPF route re-distribution. An ASBR is able to translate information from other OSPF processes in
separate areas and routes from other sources, such as static routes or other dynamic routing protocols, into the
OSPF protocol.

Mode: Global Config Mode

Privilege Level: Operator

Format: ip ospf re-distribute <P-1> [metric <P-2>] [metric-type <P-3>] [tag <P-4>]
[subnets <P-5>]
[metric]: Configure the OSPF route re-distribution metric parameters.
[metric-type]: Configure the OSPF route redistribution metric-type.
[tag]: Configure the OSPF route redistribution tag parameters.
[subnets]: Allow the router to redistribute subnets into OSPF.
Parameter Value
connected
P-1
static
0..16777214
P-2
P-3 1..2
P-4 0..4294967295
P-5 enable
disable
RM CLI EAGLE20/30
Release 04.1 03/2021
Meaning
Configure the auto cost for OSPF calculation.
Meaning
Enter the value.
Meaning
Enter the value.
Meaning
Enter the value.
Meaning
Select the source protocol as connected.
Select the source protocol as static.
Configure the metric.
Configure the metric type.
Configure the tag.
Enable the option.
Disable the option.
Open Shortest Path First (OSPF)
21.1 ip
93