Switching On/Off The Device - Abicor Binzel ABICAR ADVANCED Betriebsanleitung

ABICAR ADVANCED
Fig. 8
For the mains voltage and the fuse protection, please refer to the following sections:
 4.3 Technical data on page EN-10
 16 Circuit diagram on page EN-26
Connect the blue or green sheathed power cable to the corresponding power source. If necessary, have
1
a specialist install a plug that corresponds to the welding power source.
Plug in the weld start signal cable on the device.
2

6.5 Switching on/off the device

► Plug in the mains plug.
► To switch on the device, depress the on/off switch until it engages.
After the device has been switched on, first the current software version number will be shown on the
display. The main menu will then appear.
► To switch off the device, fully depress the on/off switch and then release it.
After approx. 6 s, the device will switch off and the display and the LED in the on/off switch will disappear.
Connecting the weld start signal cable
Welding
blue
circuit 1
blue
6 Putting into operation
green
green
Welding
circuit 2
EN - 15