Adjusting The Angle In The Ofl3 - Sauter OFL3.0 Betriebsanleitung

10.3 Adjusting the Angle in the OFL3.0

Every angle between -5° to +50° can be set on the OFL3.0. For the most commonly used
angles there are fixed points built into the lift allowing for quick setting. All other angles
can be set using the Vernier scale on the lift.
10.3.1 Setting via the Fixed Points
When setting the routing angle: One hand secures the routing motor, the other hand
releases or locks the clamping levers. The lift is equipped with a total of five clamping
levers for setting the desired angle.
Fixed Points: 0°, 15°, 22.5°, 30° and 45°
Step 1: By loosening and tightening the two black clamping levers
the router motor moves to the desired grid.
When setting larger angles, take into account the diameter of the router bit If neces-
sary, open the red locking levers
shifted to avoid contact with the reducing plate.
Step 2: Set the desired angle:
0,0° Starting point, zero position (spindle is vertical)
15,0° Move the spindle one point towards the fence
22,5° Move the spindle two points in the direction of the fence
30,0° Move the spindle three points in the direction of the fence
45,0° Move the spindle four points in the direction of the fence
(8) as well allowing the entire routing motor to be
20
(7) at the front
Points
Fig. 10 Fixed Points