Leveling The Ofl3.0 In The Router Table; Leveling The Reducing Plates In The Ofl3; Installing The Safety Guard - Sauter OFL3.0 Betriebsanleitung

8.3 Leveling the OFL3.0 in the Router Table

When the router lift is located in the recess of the table, tighten the fastening screws in
the corners. If there is minimal gap, loosen the screws a little and then use the leveli-
ng screws (4) to get a flush fit. If necessary, check with a straightedge to make sure.
Tighten the fixing screws again and check. Repeat the procedure until a perfectly flush
fit is achieved.

8.4 Leveling the Reducing Plates in the OFL3.0

If necessary, the reduction plates can be adjusted using leveling discs which can be
purchased separately (see „Accessories"),each with a disc thickness of 0.1 mm, also the
flatness of the magnetic reducing plates
to prevent tilting of the plate.

9. Installing the Safety Guard

In order to prevent the operator from unintentionally interfering with the router lift du-
ring operation, the enclosed safety guard must be attached underneath the front of the
table. It must be screwed into the table plate from below.
(5) within the insert plate can be corrected
17
Fig. 5 Safety Guard