Adjusting The Height Of The Motor In The Ofl3 - Sauter OFL3.0 Betriebsanleitung

5) Make sure the router bit is firmly in the collet and does not collide with the reducing
plate (5).
6) Make sure that the reducing plate
underneth.
! ! WARNING WARNING
When selecting the router bit, observe the maximum bit diameter permitted for the ar-
ticular router motor.
Important: In addition, the maximum size bit that can be used with the OFL3.0 is
Ø 55 mm.

10.2 Adjusting the Height of the Motor in the OFL3.0

1) To adjust the height of the cutter, first
release the lock
quarter to half turn anticlockwise.
2) By turning the fine height adjustment
(1) clockwise, the router bit is raised.
Anti-clockwise, the router bit is lowered.
One complete rotation corresponds to
4 mm, one graduation mark on the sca-
le indicates the adjustment by 0.1 mm.
Thus a fine adjustment to 1/10mm ac-
curacy is possible.
3) When you have set the desired height , Close the lock
to close it hand-tight. Check, the height after locking and make sure the router bit goes
not collide with the reduction plate
waste piece of wood.
(2) by turning it a
(5). If necessary, carry out a test operation on a
(5) sits flat and there is sre no chips or dust
19
Fig. 8 The lock
Fig. 9 Height adjustment
(2) by turning it clockwise