Sauter OFL3.0 Betriebsanleitung Seite 49

Step 3: When the router motor is in the desired grid position, re-tighten all clamping
levers and check that they are firmly seated. The clamping levers are completely closed
when they are in contact with their stop and cannot be pushed down any further.
10.3.2 Setting via vernier scale
Here, too, one hand secures the routing motor, while the other hand releases the clam-
ping levers.
Step 1: Open the black locking levers
(7). When setting larger angles, depending
on the router bit diameter, make sure that the red locking levers (8) are also
opened if necessary and that the entire router motor is moved in order to avoid hitting
the reduction plate.
Step 2:
The movable upper scale has markings in 5° steps. The fixed lower scale works in the
same way as the 0.1 mm increments on a caliper gauge. The long mark stands for +0°.
The other markings increase the angle by 1° each time. In order to be able to set the
angle accurately to the degree, it is recommended to set the next smaller grid point first.
Setting the fixed point is described in 10.3.1. Next, set the grid point starting from the
required angle, in 5° steps, adjust the vernier scale so that the long mark on the lower
scale is flush with the corresponding 5° mark on the upper scale. As a last step, adjust
the angle so that the corresponding short mark on the lower scale is flush with the mark
on the upper scale.
50° 0°
-5°
+4° +0°
Fig. 11 Vernier Scale
21