Inserting The Ofl3.0 Into The Router Table - Sauter OFL3.0 Betriebsanleitung

8.1.2 Method 2 - Cutting out without template
1) Mark a rectangle for the insert plate 307 x 230 mm (SA-OFL3.0K: 299 x 236 mm). The
cut-out is thus 1 mm larger, allowing a better fit of the insert plate.
2) Mark a second rectangle 15 mm smaller inside the first rectangle to allow for the
supporting rebate.
3) Rout out the smaller the rectangle completely from the router table top. For thicker
panels, perform the routing in several steps.
4) Set the depth of the router to 9,3 mm and rout the rebate for the insert plate.
5) Check that the rebate is deep enough. The insertion plate must be slightly below the
table top level.
6) Place the OFL with the mounted router motor into the cut-out and fasten it through
the provided mounting holes with the supplied threaded screws.
! !
WARNING WARNING
When constructing the router table, make sure that it is stable and that the necessary
safety measures have been ensured . It is recommended that DIN EN 60745-2 be ap-
plied.

8.2 Inserting the OFL3.0 into the Router Table

Now insert the router lift and motor into the recess of the router table, unplug the power
cord first and then carefully lower the lift into the recess. fix the lift to the table using
the 4 screws provided.
! ! WARNING WARNING
Make sure that the power cable of your routing motor is free before the lift is
fixed.
16