Intended Use - Sauter OFL3.0 Betriebsanleitung

Intended use

The OFL router lifts are to be operated exclusively in conjunction with a CE-compliant
router table - provided by the operator - or a third-party supplier, or with the sauter FT
routing tables described here.
The router lift is designed to accommodate defined, mains-operated routers with 43 mm
standard neck and up to 1 Nm torque. Please refer to the „Permitted routing motors"
chapter. The lift must be firmly connected to the routing table. The OFL3.0 is used exclu-
sively for mounting defined routing motors. Not for drilling machines.
Vertical and axial adjustment/adjustment of the lift during operation is not permitted
under any circumstances. Always ensure that all clamping levers are firmly and securely
locked.
Unplug the power plug from the socket and/or the battery pack from the power tool be-
fore adjusting the unit or changing accessories.
Routing only in up-cutting direction, i.e. the direction of the routing feed must always
be opposite to the direction of rotation of the routing bit. The workpiece must never be
positioned or guided between the fence and the routing bit.
Always use only the appropriate reduction plates provided for this purpose, depending
on the bit diameter. For safe working, the smallest possible diameter must be used on
the reduction plate.
To the general mode of operation:
The routing lift enables the height/routing depths and angle adjustment of the router
bit. A routing table basically allows the stationary use of commercially available manual
routers motors, but, in the special case of the OFL3.0, a vertical and/or angleadjustable
spindle can be used.
To complete the routing table further components are required, such as fences, guide
rails and safety components. These are either delivered as a set with the routing table or
must be purchased separately.
Working with the OFL3.0 requires, the motor being very securely clamped this must not
be disregarded under any circumstances.
The cleaning and lubrication by means of thin oil or silicone lubricant spray of all moving
parts is strongly recommended.
The user is liable for damage and accidents caused by improper use.
3