Operating Conditions For Ofl3.0 And Ft Router Tables - Sauter OFL3.0 Betriebsanleitung

4. Operating Conditions for OFL3.0 and FT Router Tables

Work with components listed here in must be carried out exclusively in dry environments
to exclude putting users at risk.
Parts have also not been designed for outdoor use. For this reason, work in an adequa-
tely protected workshop.
Make sure not to work in a corrosive environment to guarantee a long service life and
associated functionality as well as safety.
Compliance with additional requirements may be necessary for use in tropical climates.
For this purpose, observe the operating manual of the router or router motor or contact
us for advice.
Always work on an even, clean surface to guarantee maximum stability when routing.
Consequently, the insert plate of the router lift must always be horizontal.
Additionally make sure all conditions for the used router tables, routers, and router mo-
tors made by third-party suppliers have been complied with. For this purpose, read the
corresponding manufacturer's user manual.
Due to the increased risk of kick-back, free routing without rip fence on the table is only
possible if the free routing kit (optional accessory, part no. SA-RTS-KIT) is mounted.
Free routing should only be attempted with the spindle in the vertical position.
The mounting unit must be firmly mounted by means of a screw connection including
the locking washers included. The screws for fastening to the mounting unit should be
tightened to a torque of 13 Nm. This must be checked again before each use. This is the
only way to ensure that the screws are safely secured.
8