Adjusting The Height - Sauter OFL3.0 Betriebsanleitung

10.2 Adjusting the height

1) To adjust the height of the milling
cutter, first release the lock
turning it a quarter to half turn anti-
clockwise.
2) By turning the fine height
adjustment (1) clockwise, the router
bit is raised. Anti-clockwise, the router
bit is lowered . One complete rotation
corresponds to 4 mm, one graduation
mark on the scale indicates the
adjustment by 0.1 mm. Thus a fine
adjustment to 1/10mm accuracy is
possible.
3) When you have set the desired height , Close the lock
close it hand-tight. Check, the height after locking and make sure the router bit does not
collide with the reduction plate
waste piece.
(2) by
(5). If necessary, carry out a test milling operation on a
19
Fig. 8 The lock
Fig. 9 Height adjustment
(2) by turning it clockwise to