Ethernet Setup; Mac Address - Endress+Hauser eco-graph a Betriebsanleitung

4. Setting up unit - SET UP

4.5 Ethernet Setup

4.5.1 Menu: SETUP -
Miscellaneous -
Serial interface

4.5.2 MAC address

4.5.3 IP address allocation The device is delivered with a preset IP address which must, however, be changed in
64
3. Match the unit settings to the required parameters and select "Finished / Transmit
set-up to unit". The new set up parameters are automatically transmitted to the unit.
4. Finally the setting should be stored in the data base: select "Finished / Store set-up
into unit data base".
Before a connection can be established via the PC network, the system parameters in
the device must be set.
Note: you can obtain the system parameters from your relevant network administrator.
The following system parameters must be set:
1. IP address
2. Subnet mask
3. Gateway
All parameters that affect the device's operating system are configured in the setup -
miscellaneous menu.
The system parameters are input in the Ethernet menu.
Note: this menu only appears if the device is equipped with an internal Ethernet
interface.
This displays the Ethernet address of the device. This number is set and registered at
the factory. It cannot be changed.
the setup procedure. Before you can make the input in the device, an IP address
valid for your network must be defined.
Note: the IP address must be unique within the network.