Service - Endress+Hauser eco-graph a Betriebsanleitung

4. Setting up unit - SET UP

4.3.7 Service:

62
• Display and settings for calibration, relay operating mode etc.
• Changes must only be made by qualified skilled personnel! The unit will not
operate properly if incorrectly set up! This will result in a loss of guarantee!
• General: Information for service technician, e.g. on questions to unit/unit faults
Unit software version. Please send these details with any questions about the
SW version
unit. Is also available in normal operation under the "Unit information".
Last power on Please send these details with any questions about the unit.
Last C-assertion Please send these details with any questions about the unit.
Attention: Resets all parameters to works default settings! All previous
PRESET
values, settings and memory contents are deleted !
Display addresses In addition to the help text also display the address number being set up.
CPU no. CPU number. Please send these details with any questions about the unit.
Display of the total unit operating time. Please send these details with any
Unit running time
questions about the unit.
Display of the total operating time of the rear illumination. Please send these
LCD running time
details with any questions about the unit.
• Details for operating cost calculation
By using this unit you can save a large amount of money compared to using a strip
chart recorder! These settings can be used to calculate these savings and display
them in normal operation under "Unit information". The factory default settings are
based on typical average costs for:
• Paper
• Pens
• Order handling, logistics and personnel costs (contained in the cost for paper and
pens).