Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TMD 834
2.2 Mounting
Suitable mounting screws and holding spring are supplied with the TMD 834
transmitter. To install the transmitter into the mounting head, carefully slide the
thermometer wires through the central hole, and insert the device into the mounting
head, so the PROFIBUS-PA output terminals are positioned on the side where the
wires exit is located.
Tighten the two fixing screws with a blade screwdriver, without too much force to
avoid damaging the transmitter.
See figure below for mounting details.
Transmitter mounting details, with
sensor, head, and thermowell
Chapter 2 Installation
Mounting
33
Werbung
Kapitel
Inhaltsverzeichnis
