TMT142 HART®
2.3
Installation instructions
2.3.1 Direct wall mounting
• Drill 2 holes. Drill template and drill hole distance → Fig. 1.
Proceed as follows to mount the device directly on wall:
• Attach the device to the wall with 2 screws (M6).
2.3.2 Pipe installation
The mounting bracket is suited for pipes with a diameter between 1.5" - 3.3". Proceed as follows
to mount the device on a pipe (→ Fig. 1):
• Attach the mounting bracket to the pipe.
• The additional mounting plate must be used for pipes with a diameter of 1.5" to 2.2".
• Fix the device to the mounting bracket with the two screws supplied. The mounting plate is
not needed for pipes with a diameter of 2.2" - 3.3".
2.4
Post-installation check
After installing the device, always run the following final checks:
Device condition and specifications
Is the device visibly damaged (visual check)?
Does the device comply to the measurement point
specifications, such as ambient temperature, etc.?
Endress+Hauser
Installation instructions
Notes
-
→ Chap. 2.2
21