Setting The Direction Of Rotation; Inserting/Replacing Bits - Parkside PMBSA 4 A1 Originalbetriebsanleitung

GB IE
• Press the On/Off switch.
The state of charge of the
battery is indicated by the 3
coloured LED lights:
Red-amber-green => bat-
tery > 60%
Red-amber => battery
charged > 30%
Red => battery < 30%.
please charge
Setting the
direction of
rotation
The device's direction of rota-
tion (clockwise and counter-
clockwise) can be changed
with the direction switch.
Clockwise
direction
Counter-
clockwise di-
rection
1. Wait for the device to come
to a standstill.
2. Press the direction switch (3)
to switch between counter-
40
For tightening
screws
To unscrew
screws
clockwise and clockwise
operation.
Direction switch may only
be activated at a standstill
to prevent damage to the
transmission.
Inserting/
replacing bits
Inserting the bit holder
1. Rotate the keyless chuck (1)
counter-clockwise, until the
drill chuck aperture is large
enough to accommodate the
bit holder.
2. Insert the bit holder (12) in
the drill chuck aperture.
3. Rotate the keyless chuck (1)
clockwise in order to clamp
the bit holder.
Inserting/removing bits
4. Insert the bit (13) you want
to use in the bit holder (12).
5. To remove the bit (13), pull the
bit out of the bit holder (12).
Removing the bit holder
1. Rotate the keyless chuck (1)
counter-clockwise.