Operation; Switching On And Off; Adjusting The Rotational Speed; Changing The Direction Of Rotation - Parkside PABS 20-LI B2 Originalbetriebsanleitung

Operation

Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in (see Fig. K).
The LED work light
OFF switch is depressed lightly or fully. This
allows for illumination of the work area in low
lighting.
Switching off:
♦ Release the appliance's ON/OFF switch
switch off the appliance.

Adjusting the rotational speed

The ON/OFF switch has a variable speed con-
trol. Pressing the ON/OFF switch
low speed. Increasing pressure increases the speed
(see Fig. K).
NOTE
► The integrated motor brake ensures rapid
stoppage.

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotational direction switch
right (see Fig. L).
PABS 20-LI B2
All manuals and user guides at all-guides.com
lights up when the ON/
to
lightly yields a
towards the left or

Tips and tricks

Tip! This symbol indicates proper be-
haviour!
♦ Before operation, check whether the screw or
drill bit is correctly positioned, i.e. centred in the
drill chuck.
♦ Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check whether the bit fits tightly in the
screw head without any free play.
Torque:
♦ Smaller screws/bits can be damaged if you set
the torque or rotational speed too high.
Hard screw joints (in metal):
♦ Particularly high torques occur, for example, in
metal screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood):
♦ Again, use a low rotational speed, to avoid e.g.
damaging the surface of the wood upon contact
with the screw head. Use a countersink.
When drilling in wood, metal and other
materials, observe the following:
♦ Use a high speed for drill bits with small diameter
and a low speed for drill bits with large diameter.
♦ Select a low speed for hard materials and a
high speed for soft materials.
♦ Secure or fasten the workpiece in a clamp or
vice (if possible).
♦ Mark the spot where you want to drill using a
centre punch or nail. Select a low rotational
speed when starting.
♦ Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole.
GB │ IE │
7 ■