Changing Tools; Gear Drive; Torque Control / Drill Step; Preparing The Tool For Use - Parkside PABS 10.8 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Changing tools

Q
Your cordless drill / screwdriver has a fully automat-
ic spindle lock
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

2 Gear Drive

Q
Note: Move the gear selector switch
the device has come to a standstill.
In the first gear (Gear selector switch
in Position: 1)
you achieve a speed of approx. 400 rpm and a high
torque. This setting is suitable for all screwing tasks.
In the second gear (Gear selector switch
in Position: 2)
It achieves a speed of up to approx. 1300 rpm, for
the carrying out of drilling tasks.

Torque control / drill step

Q
You can use the torque control / drill step
adjust the torque. When the value of the torque
setting is reached, the clutch disengages the drive
connection to the chuck.
Select a low setting for small screws, soft work
material.
Select a high setting for large screws, hard
work materials and for the extraction of screws.
For drilling work, select the drill setting by putting
the torque control / drill setting into the
For drilling tasks, also push the gear selector
switch
1
Downloaded from www.Manualslib.com
.
.
, you can immedi-
).
6
1
to the front (Position: 2).
manuals search engine
Before first use / Preparing the tool for use

Preparing the tool for use

Q
Changing the direction of
Q
rotation / unlocking the device
can Unlock the device and change the direction of rota-
12
tion by pressing the rotational direction switch
to the right or to the left.

Switching ON / OFF

Q
Switching on:
To start the appliance squeeze on the ON /
OFF switch
The light
pressed ON / OFF switch
only after the working area in poor lighting conditions.
Switching off:
To stop the appliance, release the ON / OFF
1
switch
6
Changing the rotational speed:
The ON / OFF switch
control. Light pressure on the ON / OFF switch
1
causes the device to operate at a low speed. In-
creasing the pressure increases the speed.

Activating the lock

Q
Press the rotational direction switch
to middle position. The ON / OFF switch
11
now blocked.

Tips and Tricks

Q
When screwing into wood, metal and
other materials:
Screw bits are designated with their dimensions
and their shape. If you are unsure, always try
position. the particular screw bit out to see whether it sits
in the screw head without any free play.
Before you use the appliance, check to see
that the screw or drill bit is properly fitted, i.e.
located centrally in the chuck.
and then keep it pressed down.
6
comes on with a slightly or fully
10
and illuminates
6
.
has a variable speed
6
5
6
into the
5
is
6
GB 11