Operation; Removing/Inserting The Battery; Checking The Battery Charge Level; Choice Of Gear - Parkside PBSA 12 D2 Originalbetriebsanleitung

GB IE NI
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk of
serious or lethal injuries, we
recommend that persons with
medical implants consult their
doctor and the manufacturer
of their medical implant be-
fore operating the machine.

Operation

Removing/inserting the
Battery
1. To remove the battery (10) from the ap-
pliance, press the release button (11)
on the battery and pull out the battery.
2. To insert the battery (10), place it on
the guide track and push it into the ap-
pliance. It will audibly snap in.
Checking the battery charge
level
The battery's ( 10) charge level is indi-
cated by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow
=> Battery half charged
red => Battery needs
12
CY
7).
to be charged

Choice of gear

Slide the gear selector (5) to 1 or 2,
corresponding to a low or high torque
selection.
A gear change may only be per-
formed in standstill mode!
Set the direction of
rotation
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
1. Wait for the device to shut-down.
2. Clockwise direction: Press
direction switch (6) to the right.
3. Anticlockwise direction: Press
direction switch (6)
to the left.
4. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.
4).

Torque setting

You can preset the maximum torque by ro-
tating the torque adjustment ring (3).
19+1 torque levels are provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
lowest torque,
highest torque.
Steps 1 - 19
Step .