Notes On Safety; Explanation Of Symbols - Parkside PHD 170 B2 Originalbetriebsanleitung

Degree of protection ......................... IPX5
Rated/operating pressure (p) .....11,5 MPa
Max. permissible pressure (p max) ...17 MPa
Max. inflow pressure (p in max) ...0.8 MPa
Max. inflow temperature (T in max) ..40 °C
Pumping rate, water (Q)...............330 l/h
Max. pumping rate, water
(Q max) .....................................500 l/h
Sound pressure level
(L ) ..................... 81,7 dB(A); K
pA
Sound power level (L
measured ...... 94,3 dB(A); K
guaranteed .......................... 97 dB (A)
Vibration (a ) .....< 2.5 m/s
h
The values for noise and vibration were
determined according to
EN 60335-2-79:2012.
Do not exceed the maximum permitted
network impedance of 0.450 Ohms at the
electrical connection point.
The user must ensure that the device is oper-
ated only on a power supply network that
fulfils this requirement.
If necessary, the local power supply compa-
ny can be asked for the system impedance.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
= 3 dB
pA
)
WA
= 2,35 dB
WA
; K=0.15 m/s²
2
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched off
and times when it is switched on but
running without any load).

Notes on Safety

This section is concerned with the basic
safety rules when working with the pres-
sure cleaner.

Explanation of symbols

Attention!
Before beginning work, familiarise
yourself thoroughly with all the op-
erating elements, particularly with
how they function and operate. Ask
a specialist if necessary.
Attention: Remove the plug from the
socket as soon as the power lead is
damaged or cut.
Also disconnect the plug from the
socket when connecting to the water
supply or trying to eliminate leaks.
The pressure cleaner is not suitable
for direct connection to the drinking
water supply system.
Safety class II (Double insulation)
Electric appliances should not be dis-
posed of in the domestic garbage.
Operate the equipment only in
an upright and never in a re-
clined position.
CAUTION. pressure cleaners
can be dangerous if they are
not operated correctly! The
GB MT
49