Technical Data; Notes On Safety; Explanation Of Symbols - Parkside PHD 170 C2 Originalbetriebsanleitung

Technical data

Pressure washer .........PHD 170 C2
Mains connection ............. 230 V~, 50 Hz
Power consumption ....................2400 W
Mains cable length ............................5 m
High-pressure hose length.................10 m
Weight (without accessories) ........11.4 kg
Safety class ......................................
Degree of protection ......................... IPX5
Rated/operating pressure (p) .....11.5 MPa
Max. permissible pressure (p max) 17 MPa
Max. infl ow pressure (p in max) ...0.8 MPa
Max. infl ow temperature (T in max) ..40 °C
Pumping rate, water
(Q) ......................... 330 l/h; 5.5 l/min
Max. pumping rate, water
(Q max) .................. 500 l/h; 8.3 l/min
Sound pressure level
(L ) ....................... 79.9 dB; K
pA
Sound power level (L
measured ..........92.5 dB; K
guaranteed ............................... 97 dB
Vibration (a ) .....< 2.5 m/s
h
Vibration Jet gun ....................... 3.7 m/s
The values for noise and vibration were
determined according to
EN 60335-2-79:2012.
This device is intended to be operated us-
ing a mains supply network with an service
current capacity on the transfer point (house
connection) of max. 100 A per phase.
The user must ensure that the device is only
operated using a mains supply network
that meets the requirements.
If necessary, local power supply compa-
nies can be consulted with regards to the
service current capacity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
= 3 dB
pA
)
WA
= 2.18 dB
WA
; K=0.15 m/s²
2
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
II exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Notes on Safety

This section is concerned with the basic
safety rules when working with the pres-
sure cleaner.

Explanation of symbols

2
Attention!
Before beginning work, familiarise
yourself thoroughly with all the op-
erating elements, particularly with
how they function and operate. Ask
a specialist if necessary.
Attention: Remove the plug from the
socket as soon as the power lead is
damaged or cut.
Also disconnect the plug from the
socket when connecting to the
water supply or trying to eliminate
leaks.
The pressure cleaner is not suitable
for direct connection to the drinking
water supply system.
Safety class II (Double insulation)
GB
21