Cleaning, Maintenance And Storage - Parkside PHD 135 D3 Originalbetriebsanleitung

GB MT
Never use the device if there are
•
children or animals nearby. Peo-
ple nearby must wear protective
clothing.
Operation
Pay attention! Be aware of what
•
you are doing and take the ut-
most care when working with a
power tool. Do not use power
tools if you are tired or you are
under the influence of drugs, al-
cohol or medication.
High-pressure jets can be dan-
•
gerous if used incorrectly. The jet
must not be directed at persons,
animals, active electrical equip-
ment or the device itself.
Do not direct the jet at yourself or
•
others to clean clothing or shoes.
If you come into contact with
•
cleaning agents, rinse them with
sufficient clean water.
Never use the mains connection
•
cable to pull the plug out of the
socket or to pull the device. Pro-
tect the mains connection cable
from heat, oil and sharp edges.
Risk of explosion – do not spray
•
any flammable liquids.
Do not use the device near flam-
•
mable liquids or gases. There is a
risk of fire or explosion if this ad-
vice is not heeded.
Never transport the device while
•
the drive is running.
52
Switch off the device and dis-
•
connect the mains plug from the
socket. Make sure that all mov-
ing parts have come to a com-
plete stop:
when leaving the device,
•
before changing the accessories,
•
before removing obstructions or
•
loosening blockages,
before checking the device,
•
cleaning it or performing mainte-
nance work on it.
If the device starts to vibrate ab-
•
normally strong, an immediate in-
spection is required:
search for signs of damage,
•
replace damaged parts,
•
contact the service centre.
•
Cleaning, maintenance
and storage
Allow the motor to cool down
•
before storing the device for a
longer period.
Replace worn or damaged parts
•
in the interests of safety. Use only
original spare parts and acces-
sories.
The device may only be opened
•
by an authorised electrician. Al-
ways contact our service centre
for repairs.
Switch the drive off, disconnect
•
the device from the power supply
and allow the device to cool off
if you want to clean, adjust, store