Wiring
Procedure to wire the field indicator
Abb. 6: Opening the housing of the field indicator
1
Internal ground terminal (only aluminum housing)
1.
Open the cable gland and open the housing cover.
2.
Guide the cable through the cable gland.
Connect the cable as shown in å 7.
3.
4.
Tighten the cable gland again and close the housing cover.
5.
To avoid any mistakes when connecting the unit, follow the instructions in the "Post-con-
nection check" section.
5.1.2 Quick wiring guide
Terminal assignment
Abb. 7: Terminal assignment
ESD - electrostatic discharge
Protect the terminals from electrostatic discharge. Failure to observe this may result in destruc-
tion or malfunction of parts of the electronics.
34
RID16
A0011636
A0021544
Endress+Hauser