Safety Functions; Emergency Push-Button; Hood Safety Switch; Driver's Seat Microswitch - Nilfisk Floortec R 360 B Bedienungshandbuch

SAFETY FUNCTIONS

The machine is equipped with the following safety
functions.

EMERGENCY PUSH-BUTTON

It is located in an easily accessible position (8, Fig. B). It
has to be pressed in case of emergency, to stop all the
machine functions.
To reset it, turn it clockwise.

HOOD SAFETY SWITCH

It activates when the machine hood is opened: It stops all
functions.
If the machine keeps operating when the hood is open,
contact an authorised Service Center or Retailer
immediately.
WARNING!
When it is necessary to open the hood to
perform service procedures, be sure to
remove the key from the ignition switch.

DRIVER'S SEAT MICROSWITCH

It is located inside the driver's seat and it does not allow
the machine drive system to operate if the operator is not
seated on the driver's seat.
146 2596 000(3)03-2016
USER MANUAL

TROUBLESHOOTING

Trouble
The machine does not Check the battery connector (6, Fig. U) for
start when turning the proper connection.
ignition switch to "I"
Check that the hood (10, Fig. C) is closed.
position.
Check the fuse F1 in the box (9, Fig. U) for
integrity.
Check that the optional battery charger (7,
Fig. U) is disconnected from the electrical
mains.
The machine does not Check that the parking brake (6 and 7, Fig.
move by pressing the C) has been released.
pedal (5, Fig. C).
Check that the switch (19, Fig. U) is in "I"
position.
Check that the drive pedal (5, Fig. C) is not
pressed while starting the machine with the
ignition switch (2, Fig. B), or while the
operator is sitting on the driver's seat. The
drive pedal (5, Fig. C) has to be pressed
only after the operator has sit on the
driver's seat and the machine has been
started.
The side brooms do Check the fuse F6 in the box (9, Fig. U) for
not operate. integrity.
The machine operates Charge the batteries. If the trouble
only when stationary, persists, replace the batteries.
otherwise it switches
off and the red warning
light (3, Fig. B) flashes.
Battery autonomy is Install batteries having higher capacity
low. (minimum 100 Ah C5).
NOTE
If the machine has been supplied with the
optional battery charger, the machine cannot
operate if the charger is not on board. In case
of battery charger malfunction, contact an
authorised Service Center.
For further information, refer to the Service Manual,
available at any Nilfisk-Alto Service Center.

SCRAPPING

Have the machine scrapped by a qualified scrapper.
Before scrapping the machine, remove the following
materials, which must be disposed of properly according
to the law in force.
– Batteries
– Polyester dust filter
– Main and side brooms
– Electrical and electronic components (*)
– Plastic components and hoses
(*) Refer to the nearest Nilfisk-Alto Center especially
when scrapping electrical and electronic components.
ENGLISH
Remedy
FLOORTEC R 360 B 17