Main Broom Replacement; Side Broom Height Check And Adjustment - Nilfisk Floortec R 360 B Bedienungshandbuch

MAIN BROOM REPLACEMENT

NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
CAUTION!
It is advisable to use protective gloves
when replacing the side brooms because
there can be sharp debris between the
bristles.
1. Drive the machine on a level ground and engage the
parking brake (6 and 7, Fig. C).
2. Turn the ignition switch (2, Fig. B) to "0" position.
3. Loosen the knobs (1, Fig. E) on both sides of the
machine.
4. Move the broom height variation indicators (2, Fig. E)
until the broom is at the maximum distance from the
ground. Screw down the knobs (1).
5. Open the hood (10, Fig. C).
6. On the left side of the machine, loosen the knob (3,
Fig. E).
7. Remove the broom door (1, Fig. F) by pulling it
upwards to disengage the retainers (2).
8. Remove the broom (1, Fig. G).
9. Check also that the drive hub (4, Fig. R) is free from
dirt or foreign materials (ropes, rags, etc.)
accidentally rolled up.
10. The new broom must be installed with the bristles
rows bent as shown in the figure H (top view).
11. Install the new broom on the machine and ensure that
its mesh (1, Fig. I) correctly fits into the relevant drive
hub (4, Fig. R). Check that the drive hub is free from
dirt or foreign materials (cords, rags, etc.)
accidentally rolled up.
12. Install the broom door (1, Fig. F) by engaging the
retainers (2).
13. Screw down the knob (3, Fig. E).
14. Carry out the main broom height check and
adjustment, as shown in the previous paragraph.
146 2596 000(3)03-2016
USER MANUAL
SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
1. Check the side broom height from the ground,
according to the following procedure:
– Drive the machine on a level ground and lower the
side brooms.
– Keep the machine stationary, lower the side
brooms and rotate them for a few seconds;
– Stop and lift the side brooms, then move the
machine and switch it off.
– Check if the size and orientation of the prints left
by the side brooms are as shown in the figure (1
and 2, Fig. J).
If the print (1) is not within specifications, it is
necessary to adjust the broom height, according to
the procedure shown in step 2.
2. Unlock the ring nut (36, Fig, C) by turning it
counterclockwise, then turn the knob (33) as
necessary, clockwise or counterclockwise, to adjust
the broom height; then lock the knob (33) with the ring
nut (36).
3. Perform step 1 again to check the proper adjustment
of the side broom height from the ground.
4. When the brooms are too worn to be adjusted,
replace them as shown in the next paragraph.
ENGLISH
FLOORTEC R 360 B 13