Skirt Height And Operation Check - Nilfisk Floortec R 360 B Bedienungshandbuch

SKIRT HEIGHT AND OPERATION CHECK

1. Drive the machine on a level ground that is suitable
for checking the skirt height. Engage the parking
brake (6 and 7, Fig. C).
2. Turn the ignition switch (2, Fig. B) to "0" position.
Side skirt check
3. Check the side skirts (16 and 17, Fig. C) for integrity.
Replace the skirts when they have cuts (1, Fig. N)
larger than 20 mm or cracks (2) larger than 10 mm
(for skirt replacement, refer to the Service Manual).
4. Check that the side skirt (16 and 17, Fig. C) height
from the ground is within 0 – 3 mm (Fig. O). If
necessary, adjust the skirt height, according to the
following procedure:
Left skirt:
– Open the hood (10, Fig. C) and engage the hood
support rod (3, Fig. U).
– Loosen the knob (3, Fig. E) and remove the broom
left door (1, Fig. F), pulling it upwards to
disengage the retainers (2).
– Adjust the skirt (3, Fig. F) height by using the slots
(4).
– Assemble in the reverse order of disassembly.
Right skirt:
– Remove the main broom, as shown in the relevant
paragraph.
– Remove the belt (14, Fig. U) from the pulley (15);
for a easier removal, turn the pulley (15) by
operating on the vacuum fan (16) manually.
– Remove the screws (27, Fig. C) and the right door
(26) together with the belt (14, Fig. U). Adjust the
skirt (1, Fig. S) height by using the slots (2).
– Assemble in the reverse order of disassembly.
146 2596 000(3)03-2016
USER MANUAL
Front and rear skirt check
5. Remove the main broom, as shown in the relevant
paragraph.
6. Check the front (1, Fig. R) and rear (2) skirts for
integrity.
7. Replace the skirts when they have cuts (1, Fig. N)
larger than 20 mm or cracks (2) larger than 10 mm
(for skirt replacement, refer to the Service Manual).
8. Check that:
– The front skirt (1, Fig. R) slightly touches the
ground and that it is not detached from the ground
(1, Fig. P).
– The rear skirt (2, Fig. R) height from ground is
within 0 - 3 mm (1, Fig. O).
9. If necessary, adjust the skirt height by using the slots
(3, Fig. R).
10. Press the front skirt lifting pedal (8, Fig. C) and check
that the front skirt (1, Fig. Q) rotates upward of about
90° (as shown in figure); release the pedal and check
that the skirt does not remain in an intermediate
position but returns to its initial position. If necessary,
for the front skirt control cable adjustment or
replacement, refer to the Service Manual.
11. Assemble in the reverse order of disassembly.
ENGLISH
FLOORTEC R 360 B 15