Side Broom Replacement; Dust Filter Cleaning And Integrity Check - Nilfisk Floortec R 360 B Bedienungshandbuch

USER MANUAL
ENGLISH

SIDE BROOM REPLACEMENT

NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
CAUTION!
It is advisable to use protective gloves
when replacing the side brooms because
there can be sharp debris between the
bristles.
1. Drive the machine on a level ground and engage the
parking brake (6 and 7, Fig. C).
2. Turn the ignition switch (2, Fig. B) to "0" position.
3. Introduce the hand inside the side broom and press
the tabs (1, Fig. K) inwards, then remove the broom
(2) disengaging it from the four pins (3).
4. Install the new broom on the machine engaging it on
the pins (3) and on the tabs (1).
5. Carry out the side broom height check and
adjustment, as shown in the previous paragraph.
DUST FILTER CLEANING AND INTEGRITY
CHECK
NOTE
Besides the standard paper filter, polyester
filters are also available. The following
procedure is applicable to each type of filter.
1. Drive the machine on a level ground and engage the
parking brake (6 and 7, Fig. C).
2. Turn the ignition switch (2, Fig. B) to "0" position.
3. Remove the hopper hook (21, Fig. C).
4. Remove the hopper (20, Fig. C) by using the handle
(22).
5. Turn the handle (1, Fig. L) downwards (90°
approximately) and let the filter frame (2) rotate
outwards.
6. Remove the dust filter (3).
14 FLOORTEC R 360 B
7. In an appropriate outdoor area, clean the filter by
shaking it on a level and clean surface, tapping the
side (1, Fig. M) opposite to the wire gauze (2).
Complete the cleaning by using compressed air (3) at
maximum 6 bars, blowing only from the side
protected by the wire gauze (2), at a minimum
distance of 30 cm.
According to the filter type, observe the following
cautions:
– Paper filter (standard): Do not use water or
detergents to clean it; the filter can be damaged.
– Polyester filter (optional): To clean it, see the
above-mentioned instructions. If necessary, for a
better cleaning, it is allowed to wash the filter with
water and non-lathering detergents. This provides
better quality cleaning but reduces the life of the
filter, which will have to be replaced more
frequently. The use of inadequate detergents can
damage the filter.
8. Check the filter body for tears.
9. If necessary, clean the filter compartment rubber seal
(4, Fig. L) along its perimeter and check it for integrity.
If necessary, replace it.
10. Assemble in the reverse order of disassembly.
NOTE
Assemble the filter with the wire gauze (2, Fig.
M) facing the vacuum fan (16, Fig. U).
146 2596 000(3)03-2016